C
3
HAPTER
FIGURE 3. Secured Base End Bracket
NOTE:
The hole for mounting the WAS base end should be towards the inside of the machine.
4. Using the provided 3/8" bolt (P/N 311-0054-058), 3/8" lock nut (P/N 312-4000-061), and steel spacer (P/N 170-
0172-103), install the base end of the WAS.
FIGURE 4. Installed WAS Base End
5. On the rod end of the steering cylinder, install the provided 1.75" U-bolt (P/N 135-3003-052), so that the ends
of the U-bolt are positioned at a 45° angle towards the ground. Do not fully tighten the U-bolt hardware at this
time.
10
Case IH Trident 5550 - Non-Steer Ready, Raven RS1™ HDU Guidance and Steering Installation Manual
Installed Base
End Bracket