Install The Tank Hose - Raven RS1 Guidance And Steering Installation Manual

FIGURE 6. Pressure Hose Installed
Machine's
Tank Port
Center Bolts of
Machine's Front
Axle
3. Install a -8 ORFS M/M/F swivel run tee adapter fitting (P/N 333-0012-028) on the block above the rear of the
front axle.
4. Connect the machine's pressure hose to the opposite end of the installed tee fitting.
5. Install the supplied hydraulic hose (P/N 214-1000-630) on the 90° end of the installed tee fitting.
6. Connect the straight end of the installed hydraulic hose to the 90° fitting (333-0012-065) on Port P of the
Raven steering valve.

INSTALL THE TANK HOSE

1. Locate the machine's tank line.
NOTE: The pressure and tank line connect to a block above the front axle on the rear side.
2. Disconnect the machine's tank hose from the block.
FIGURE 7. Tank Hose Installed
Tank Port Located
to the Left of the
Pressure Port
3. Install a -8 ORFS M/M/F swivel run tee adapter fitting (P/N 333-0012-028) on the machine's hydraulic block.
4. Connect the machine's tank hose to the opposite end of the installed tee fitting.
5. Install the -8 end of the supplied hydraulic hose (P/N 214-1000-630) on the 90° end of the installed tee fitting.
6. Connect the other end of the installed hydraulic hose to Port T of the Raven steering valve.
P/N 016-5032-121 Rev. A
Hydraulic System Installation: Install the Tank Hose
Installed
Pressure
Hose
Pressure Port
17