Table of Contents
Advertisement
1
2
46
1
5.2-5
3
5
4
5.2-4
Operations
•
From the disc on tire contact position, activate the
lever 1 downwards.
•
Hold the control down for the entire time in which
you wish to vary the angle.
Lower bead breaking
To break the second bead, it may be necessary to
free the work area of the Upper Bead Breaker Arm;
especially for very wide wheels.
Proceed as follows:
Figure 5.2-5
•
(If necessary) Activate the control 1 (Fig. 5.2-5) to
bring the Upper Bead Breaker Arm outside its work
zone.
•
Lift the command 4 (Fig. 5.2-4), to move the Lower
Disc in the bead breaking position to break the lower
bead.
WARNING: CHECK THAT THE DISC IS CORRECTLY
POSITIONED ON THE SIDEWALL OF THE TIRE,
NEXT TO THE RIM
• Activate rotation and lubricate the bead breaking
zone.
• Proceed with bead breaking as described for the
upper bead by activating the disc 'up' control as
opposed to the disc 'down' control.
Check the bead breaking state with the mirror at the
bottom of the post.
WARNING: IF NECESSARY BEAD BREAKING CAN
BE AIDED BY USING THE BEAD BREAKER DISC
PENETRATION ANGLE VARIATION CONTROL
Note:
The disc penetration angle variation
control can also be used for the lower
bead, (Control 2, Fig. 5.2-4).
•
Activate the control (5, Fig.5.2-4) to release the
Bead Breaker Arms and move them out of the work
area.
Operator's Manual
Advertisement
Table of Contents
