Advertisement
TLP Pro 1225MG, 1525MG, and 1725MG • Setup Guide
Rear Panel Features
Figure 2 shows the TLP Pro 1225MG rear panel. The TLP Pro 1525MG and TLP Pro 1725MG features are very similar.
A
B
C
D
E
F
TLP Pro 1225MG Rear Panel
Figure 3.
A
Mounting plate notch (2) — Fit over the hooks at the top of the mounting plate (see
B
RESET LED — Provides feedback about the reset status when the user presses the reset button.
C
RESET button — Pressing the RESET button allows the unit to be reset in any of three different modes (see
a Brief Summary
on page 5). For more information, see the TLP Pro 1225, TLP Pro 1525, and TLP Pro 1725 Series User
Guide.
D
MENU button — Activates the setup menu (see
E
USB connectors (2) — For peripheral controls.
F
Mounting screw slot (2) — Insert the provided screws here to secure the touchpanel to the mounting plate.
G
Audio output — One 3.5 mm line level audio output for use with headphones or assistive listening devices.
H
HDMI input — For alternative video input.
I
XTP/LAN/PoE input
XTP input — Connect the touchpanel to an Extron XTP
z
connector. For complete information about which cables to use, see the user guide for your XTP product.
LAN input — Connect the touchpanel to the LAN using a twisted pair cable, terminated with an RJ-45 connector.
z
PoE input — the connector can be used with a PoE power injector (see
z
NOTE: Some XTP models are able to remotely power these touchpanels but not all have that capability. Go to the
website
and check the product page for your XTP model to ensure it can power your touchpanel.
An Extron IP Link Pro control processor must also be connected to the same network as the TouchLink Pro touchpanel.
4
RESET
HDMI IN
MENU
XTP /
LAN /
PoE
1
2
Setup Menu
Wall Mounting
).
source using a twisted pair cable, terminated with an RJ-45
®
Connecting Power
A
G
H
I
on page 2).
Reset Modes:
on page 5).
Extron
Advertisement
