Led Display When The Emulator Starts Up Normally - Renesas M306K9T2-CPE User Manual

(3) LED Display When the Emulator Starts Up Normally

After the emulator starts up, check the status of the LEDs to see whether the emulator operation is
enabled or not.
System status LED
Target status LED
Figure 2.10 Positions of system status LEDs and target status LEDs
(1) System status LEDs
Check that the LED1 of the system status LEDs is lit immediately after the power is activated.
If it is not lit, shut off the emulator and check the power supply for the emulator is properly
connected.
(2) Target status LEDs
Target status LEDs light as shown in Figure 2.11 when the target system is not connected and as
shown in Figure 2.12 when a target system is connected. For about 5 seconds after power is
turned on, all the target status LEDs light. After that, make sure the target status LEDs light
up normally.
If the target status LEDs do not light as shown in Figure 2.11 or Figure 2.12, see "5.1
Troubleshooting Until the Emulator Starts Up" (page 44).
When the target system NOT connected:
The POWER LED does not light.
: ON
: OFF
Figure 2.11 LED display when the emulator starts up normally (target not connected)
When the target system connected:
If the POWER LED does not light, shut off
the system and check the setting of the
jumper switches and if the power is properly
supplied to the target system.
: ON
: OFF
Figure 2.12 LED display when the emulator starts up normally (target connected)
LED1
POWER
SAFE
LED2
LED3
POWER
CLOCK
RESET
RUN
LED6
COMPACT EMULATOR
( 26 / 56 )
J2
J1
MADE
POWER LED3
CLOCK
LED4
RESET
LED5
LED6
RUN
POWER LED3
CLOCK
LED4
RESET
LED5
LED6
RUN
SW1