R0E510Y47LVB00
Low voltage OCD Board for RL78/G10 Groups
1.
Overview
R0E510Y47LVB00 is a debug board for R5F10Y47ASP, R5F10Y46ASP, R5F10Y44ASP, R5F10Y17ASP, R5F10Y16ASP,
R5F10Y14ASP in RL78/G10 groups, which is enabled to effective debug of hardware and software on low voltage user system.
This product is used with E1 emulator. And a box connector of 2.45mm pitch is needed to connecting user system.
Also refer to E1/E20 Emulator Additional Document for User's Manual (Notes on Connecting RL78), when you use this product.
Host machine
USB interface cable
E1 emulator
2.
Specifications
Table 1 shows the functional specifications of this product.
Item
Target MCU
Support Emulator
Target I/F
Power supply for this product
Operating voltage
Operating temperature
Storage temperature
Dimensions
Weight
1
Note*
: If the user system power supply is turned on be before starting debugger, this product uses 150mA current
from user system.
2
Note*
: It is different from target devices. The operation voltage range of this product is 5.0V(max.)
R20UT2886EJ0100 Rev.1.00
Jan 20, 2014
User interface cable
* Do not mount target device on user system.
If target device is mounted, the signals are shorted between
this product and target device on user system.
Figure 1
System Configuration
Table 1
Specifications of this product
R5F10Y17ASP, R5F10Y16ASP, R5F10Y14ASP (10pin SSOP)
R5F10Y47ASP, R5F10Y46ASP, R5F10Y44ASP (16pin SSOP)
E1 emulator (E20 emulator is not supported )
8510-4500 : 10-pin type connecter, Sumitomo 3M Limited
8516-4500 : 16-pin type connecter, Sumitomo 3M Limited
Emulator or Target system*
2
2.0V to 5.0V*
5 to 35
°C
(No condensation)
-15 to 60
°C
(No condensation)
65mm * 70mm (Does not include projection) Refer to figure2.
22g
RE510Y47LVB00
User system
Specification
1
User's Manual
R20UT2886EJ0100
Rev.1.00
Jan 20, 2014
Page 1 of 9