On/Off Switch For Mower System - Husqvarna RB150 Workshop Manual

A. ON/OFF switch for mower
system
Trouble shooting the ON/OFF switch for mower
system
The pins that are to make contact with each other in
the respective modes are marked with a cross (X).
Measure the resistance between the pins with an
ohmmeter. The resistance may not exceed 0.5 .
Resistance between the other pins is to be more
than 1000 .
Dismantling
1. Fold the engine hood forward.
2. Mark the cables with tape to simplify
identification when refitting.
3. Disconnect the cables.
4. Remove the nut (3) and lock washer, and pull
out the switch at the back of the instrument
panel.
Mounting
1. Insert the switch at the back of the instrument
panel, and fit it with the lock washer and nut (3).
2. Place the marked cables in position.
ELECTRICAL SYSTEM
5MA
1
U
6
2
1 2 6 U 5MA
E
3
English – 43