Step 12: Auto Mode Operation - YASKAWA iQpump Micro Quick Start Manual

iQpump Micro
Quick Start Procedure
STEP
AUTO Mode Operation
12
12.1 AUTO Mode
The iQpump Micro is operated in AUTO mode by performing the following tasks: Program all parameters
• Verify motor rotation direction
• Auto Mode: Select the Reference source setting in parameter b1-01
• Auto Mode: Select the Run source setting in parameter b1-02 (Refer to STEP 4)
PRESS AUTO BUTTON
Press the AUTO button to place the iQpump Micro into AUTO mode .
The AUTO mode will start and stop based on the Run Source Selection setting parameter b1-02. (Refer to Step 3) The
Reference Source Selection parameter b1-01 setting configures the AUTO mode reference source.
12.2 Set System Setpoint
Press
to access or modify the system setpoint in parameter Q1-01 within the iQpump Micro Quick Setup Menu.
iQpump Micro Quick Setup Menu.
Next press
5 80. 0
5 80. 0
The iQpump Micro starts in AUTO Mode when the feedback signal level falls below the level programmed in parameter
P1-04 for the specified time in P1-05.
Refer to STEP 8,
parameter P1-04 for
details on the Start
Level Function.
LED Digital Operator (Standard)
5 80. 0
SETPOINT
PRESS TO TURN OFF
LED is blinking
when AUTO mode
is active but AUTO
Run Command is
not active.
Figure 4: Digital Operator
LED Digital Operator (Standard)
Use
to select the digit and
to store setpoint.
Example: 80 PSI
Press the AUTO button to
start the iQpump Micro.
Start Level Delay (P1-05)
145 PSI
(Example 5.0 sec.)
Start
WAIT
Delay
0
Feedback signal from
pressure transducer
(4 – 20 mA)
Start Pump System
YASKAWA TOEP YAIQPM 01A iQpump Micro Quick Start Procedure
. Next press
to store setpoint.
Start / Draw Down
Level P1-04
System Setpoint
(Example 80 PSI)
Page 27
of 31