YASKAWA iQpump Micro Quick Start Manual page 9

iQpump Micro
Quick Start Procedure
STEP
Install the 24 V Transducer Power Supply (continued)
5
5.6 Installation Procedure
5.7
Shut off power to the drive. Wait at least five minutes after confirming the DC bus voltage is safe.
On IP20/NEMA 1, UL Type 1 models, loosen the screw that fastens the front cover in place and remove the front
cover. This drive front cover will be replaced by the 24V Power Supply cover. Cover removal varies depending on
drive size.
On IP66/NEMA 4X, UL Type 4X models, loosen the 4 bolts that attach the enclosure front cover in place, gently
move the front cover away from the enclosure, press firmly on the digital operator cable connector release tab to
disconnect the cable from port CN1 on the drive, then remove the front cover. Refer to
size.
IP20/NEMA 1, UL Type 1
Voltage Class
Single-Phase 200 V Class
Three-Phase 200 V Class
Three-Phase 400 V Class
5.8
On IP20/NEMA 1, UL Type 1 enclosure models, loosen the screw on the front of the bottom cover and remove it from
the drive. All models except 2V0006F require removing a plastic lower terminal cover prior to removing the bottom
cover.
On IP66/NEMA 4X, UL Type 4Xenclosure models, remove the lower terminal cover (if provided) from the drive.
The lower terminal cover is not present on certain models.
Table 1.2 Remove the Drive or Enclosure Front Cover
Table 1.3 IP66/NEMA 4X, UL Type 4X Enclosure Front Cover Installation Bolt Size
Models With
Lower Terminal Cover
Lower
Terminal Cover
IP66/NEMA 4X, UL Type 4X
Drive Model
BV0001G to BV0012G
2V0001G to 2V0020G
2V0030G to 2V0069G
4V0001G to 4V0011G
4V0018G to 4V0038G
Models Without
Lower Terminal Cover:
BV0001 to BV0003 and
2V0001 to 2V0006
YASKAWA TOEP YAIQPM 01A iQpump Micro Quick Start Procedure
Table 1.3 for installation bolt
Port
CN1
Digital
Connector
Operator
Release Tab
Cable
Installation Bolt Size
M5
M5
M6
M5
M6
Page 9
of 31