iQpump Micro
Quick Start Procedure
STEP
Install the 24 V Transducer Power Supply (continued)
5
5.13
Connect the ground wire to the 24V Power Supply at ground terminal FE.
Route the free end of the ground wire to the front of the 24V Power Supply via the through-slot as shown in
1.10
and connect the ground wire. Tighten the screw to 0.5 ~ 0.6 Nm or (4.4 ~ 5.3 in lbs) using an M3 Phillips
screwdriver.
5.14
Connect the white J2 lead wire to terminal A2 on drive terminal block TB1-2.
Route the free end of the J2 wire to the A2 terminal on the drive via the through-slot on the 24V Power supply as
shown in
Table
1.11.
YASKAWA TOEP YAIQPM 01A iQpump Micro Quick Start Procedure
Table 1.10 Connect Ground Wire to 24V Power Supply
IP20/NEMA 1, UL Type 1 and IP66/NEMA 4X, UL Type 4X
J2
Through-slot
for 24V Power
Supply Wiring
Table 1.11 Connect J2 Lead Wire to Drive
IP20/NEMA 1, UL Type 1 and IP66/NEMA 4X, UL Type 4X
J2 Lead Wire
(White)
J2
Through-slot
for 24V Power
Supply Wiring
Ground Wire
FE
A2
TB1-2 (A2) Terminal
Ground Wire
FE
Page 12
of 31
Table