Step 6: Adjust And Monitor Iqpump Micro Settings - YASKAWA iQpump Micro Quick Start Manual

iQpump Micro
Quick Start Procedure
STEP
Adjust and Monitor iQpump Micro Settings
6
6.1 Access the Parameter Menu and Change Parameter Values. DO NOT RUN THE
MOTOR. Ensure all protective covers are installed and power is turned on.
Refer to the iQpump Micro User Manual, (Document No. TOEPYAIQPM03) to access additional drive monitors
LED Digital Operator (Standard)
iQpump Micro digital operator
power-up state
Press
two times until
the digital operator shows the parameter
.
menu (PAr) then press
Press to select the digit
you would like to change. Next use
and to select the
parameter group, sub-group or number.
Modify the parameter value using
and and press
to save the new value.
Monitor Motor Frequency and Current (Standard)
iQpump Micro digital operator
power-up state
Press until the FOUT
LED turns on. The display now shows
the actual drive output frequency in Hz.
Pressing again will
show the motor output current. The 'A'
behind the value means 'Amps'.
5 0. 0 0
paR
Select Parameter Menu
C1-01
Select Parameter
0010. 0
5 00. 0
42. 7 8
Output Frequency
0. 8 a
Motor Current
YASKAWA TOEP YAIQPM 01A iQpump Micro Quick Start Procedure
Page 19
of 31