YASKAWA iQpump Micro Quick Start Manual page 10

iQpump Micro
Quick Start Procedure
STEP
Install the 24 V Transducer Power Supply (continued)
5
Note: The lower terminal cover is required for secure mounting of the 24V Power Supply on the models shown in
your Yaskawa representative for ordering if you have a model listed in
on your drive.
Lower Terminal Cover on All Models
Except Models:
BV0001 to BV0003
2V0001 to 2V0006
5.9
On IP20/NEMA 1, UL Type 1 enclosure models, loosen the screws attaching the NEMA 1, UL Type 1 conduit bracket
to the drive to allow the bracket to swing out to provide easier access to the ground screw. Do not remove the
screws.
5.10
Remove the 24V Power Supply cover.
YASKAWA TOEP YAIQPM 01A iQpump Micro Quick Start Procedure
Table 1.4 Lower Terminal Cover Part Number by Model
Drive Model
BV0006 and BV0010
2V0010 and 2V0012
4V0002 to 4V0009
BV0012
2V0020
4V0011
Other models
Table 1.5 Remove the Bottom Cover and Lower Terminal Cover
IP20/NEMA 1, UL Type 1
Bottom Cover on All Models
Table 1.6 Loosen Conduit Bracket Screws
IP20/NEMA 1, UL Type 1
Table 1.7 Remove 24V Power Supply Cover
IP20/NEMA 1, UL Type 1 and IP66/NEMA 4X, UL Type 4X
Mounting Slot
Mounting Tab
Table 1.4 and the lower terminal cover is not present
Terminal Cover Part Number
Mounting Tab Mounting Slot
24V Power Supply Cover
Table 1.4. Contact
CVST31300
CVST31301
Not required
IP66/NEMA 4X, UL Type 4X
Terminal Cover on Models
BV0006G to BV0010G
2V0010G to 2V0020G
4V0002G to 4V0011G
IP66/NEMA 4X, UL Type 4X
Not applicable.
Page 10
of 31