YASKAWA iQpump Micro Quick Start Manual page 13

iQpump Micro
Quick Start Procedure
STEP
Install the 24 V Transducer Power Supply (continued)
5
5.15
On models BV0006
J2 lead wire into the terminal cover wire notch.
After inserting the ground wire and J2 lead wire into the notch, attach the terminal cover to the 24V Power Supply.
5.16
Attach the 24V Power Supply or 24V Power Supply/Terminal Cover combination to the drive.
Properly seat the tabs on the left and right sides of the 24V Power Supply unit into the drive case mounting slots and
snap into place.
NOTICE: Damage to Equipment. Take proper precautions when attaching the 24V Power Supply to the drive so that no cables
are pinched between the 24V Power Supply and the drive. Failure to comply may result in damage to circuitry and equipment.
to BV0018 , 2V0010 to 2V0020 , and 4V0002
Table 1.12 Insert Wires Into Routing Notch
IP20/NEMA 1, UL Type 1 and IP66/NEMA 4X, UL Type 4X
Terminal Cover
To 24V
Wire Routing Notch
Power Supply
J2
Table 1.13 Connect Terminal Cover to 24V Power Supply
IP20/NEMA 1, UL Type 1 and IP66/NEMA 4X, UL Type 4X
Terminal
Cover
J2
Table 1.14 Attach 24V Power Supply to Drive
IP20/NEMA 1, UL Type 1 and IP66/NEMA 4X, UL Type 4X
to 4V0011 , insert the ground wire and
To Drive
Ground Wire and
J2 Lead Wire
24V Power
Supply
YASKAWA TOEP YAIQPM 01A iQpump Micro Quick Start Procedure
Page 13
of 31