If you installed the optical media drive as part of another procedure, return to that
■
procedure.
Otherwise, perform the following tasks to bring the server back online:
■
■
■
Related Information
"Remove the Optical Media Drive" on page 91
■
Replacing the Media Bay Assembly
These tasks describe how to remove and replace the media bay assembly.
Note -
configurations to two drive and optical media drive configurations are not supported.
"Remove the Media Bay Assembly" on page 93
■
"Install the Media Bay Assembly" on page 97
■
Related Information
"Replacing a Drive" on page 85
■
"Replacing the Optical Media Drive" on page 91
■
Remove the Media Bay Assembly
Prepare the server for service.
1.
See
"Preparing the Server for Component Replacement" on page
2.
Remove the air duct.
See
"Remove the Air Duct" on page 127
3.
Remove all the drives from the system.
Make a note of the locations of each drives.
"Close Front Bezel" on page 85
"Remove Antistatic Measures" on page 212
Because of EMI compliance requirements, field upgrades between four drive system
Replacing the Media Bay Assembly
75.
Replacing Storage Components
93