Table of Contents
Advertisement
Install the Media Bay Assembly
FIGURE 9
Figure Legend
1
SATA cable from motherboard (connected on optical media drive-equipped servers only)
2
Power/signal cable from the PDB
3
SAS cable from the SAS HBA
6.
Install the optical media drive and the drives into the same slots that you
removed them.
"Install the Optical Media Drive" on page 92
■
"Install a Drive" on page 89
■
"Close Front Bezel" on page 85
■
Consider your next step:
7.
If you installed the media bay bracket as part of another procedure, return to that procedure.
■
Otherwise, continue to the next step.
■
Install the air duct.
8.
98
Sun Netra X4270 Server • September 2015
Connecting the Media Bay Assembly Cables
Advertisement
Table of Contents
