Table of Contents
Advertisement
"Close Front Bezel" on page 85
■
"Replacing a Drive" on page 85
■
"Replacing the Optical Media Drive" on page 91
■
"Replacing the Air Filter" on page 179
■
Close Front Bezel
Hold the green tabs on either side of the bezel, and lift up until the bezel snaps in
place.
Related Information
"Open Front Bezel" on page 84
■
Replacing a Drive
Note -
supported brackets.
"Drives Hot-Plug Conditions" on page 85
■
"Remove a Drive" on page 86
■
"Install a Drive" on page 89
■
Related Information
"Opening and Closing the Front Bezel" on page 83
■
Drives Hot-Plug Conditions
The solid-state or hard-disk drives in the server are hot-pluggable, but this capability depends
on how the drives are configured. To hot-plug a drive you must be able to take the drive offline
before you can remove it. When you take the drive offline, you prevent any application from
accessing the drive and remove the logical software links to the drive.
The following situations inhibit the ability to perform hot-plugging of a drive:
To ensure performance and reliability, only use carrier-grade NEBS-certified drives with
Close Front Bezel
Replacing Storage Components
85
Advertisement
Table of Contents
