Table of Contents
Advertisement
Power Down Server For an Emergency
This task quickly forces the server???s main power off. You might corrupt your
Caution -
system data during an emergency power down, so only use this task to power down the server
after attempting the graceful power down tasks.
Press and hold the power button for four seconds to force the main power off
1.
and to enter standby power mode.
When main power is off, the power OK LED on the front panel will begin flashing, indicating
that the server is in standby power mode. See
Disconnect the power and data cables from the server.
2.
See
"Disconnect Cables From the Server" on page
Caution -
When you use the Power button to enter standby power mode, power is still directed
to the service processor remote management subsystem and power supply fans. To completely
power off the server, you must disconnect the AC or DC power cords from the back of the
power supplies.
Related Information
"System Status LEDs" on page 19
■
"Power Down Server Gracefully" on page 76
■
Power Down Server For an Emergency
"System Status LEDs" on page
80.
19.
Preparing for Service
79
Advertisement
Table of Contents
