Table of Contents
Advertisement
See
"Preparing the Server for Component Replacement" on page
2.
Follow these instructions to remove the following components and place them
on an antistatic mat:
"Remove the Air Duct" on page 127
■
"Remove the PCI Mezzanine" on page 102
■
"Remove a PCIe2 Riser" on page 108
■
"Remove the Media Bay Assembly" on page 93
■
"Remove Fan Tray 0" on page 189
■
"Identify and Remove Faulty DIMMs" on page 137
■
"Remove a Flash Module" on page 144
■
"Remove the Flash Module Cable" on page 147
■
"Remove ESM Riser" on page 152
■
"Remove a CPU" on page 160
■
3.
Remove the short ribbon cable connected to the PDB.
4.
Disconnect the red SATA cable connected to the media bay assembly.
If your system does not have an optical media drive, there will be one cable to detach.
Remove the Motherboard Assembly
75.
Replacing Motherboard Assembly Components
169
Advertisement
Table of Contents
