Table of Contents
Advertisement
Install a Power Supply
Listen for the audible click when the power supply fully seats.
Reconnect the power cord to the power supply.
4.
Verify that the amber LED on the replaced power supply and the service required
5.
LEDs are not lit.
Log in to the ILOM service processor as root.
6.
Refer to the ILOM 3.0 documentation for instructions.
7.
At the ILOM prompt (->), type the show /SYS/PSn command to verify the status of
the power supplies.
In this command, PSn is the identifier for the power supply you plan to remove, either PS0 or
PS1.
Related Information
"Rear Panel Cable Connections" on page 17
■
"Power Supply LEDs" on page 23
■
"Remove a Power Supply" on page 184
■
188
Sun Netra X4270 Server • September 2015
Advertisement
Table of Contents
