Table of Contents
Advertisement
1.
Mark the location of two mounting holes, 4.96 inches (126.0 mm) apart. This measurement
is the same for the TLP Pro 1225TG, 1525TG, and 1725TG.
2.
Drill two pilot holes into the desktop.
3.
Remove the cover of the touchpanel base.
4.
Insert two #10 flat-head wood screws (not provided) through the touchpanel and align them
with the two pilot holes.
5.
Secure the touchpanel to the tabletop.
6.
Replace the cover to the base.
Placement with a Kensington Security Lock
Figure 31.
For added security, attach a Kensington Security Lock (not provided) to the metal-reinforced slot
on the rear edge of the base. Figure 31 shows the rear edge of the TLP Pro 1225TG base. The
bases of the TLP Pro 1525TG and 1725TG are very similar.
Follow the instructions that are provided by the manufacturer to install the lock.
Placement with a SMA-1 swivel mount adapter
All three touchpanels can also be mounted with the optional Extron SMA-1 swivel mount adapter,
which allows them to be mounted permanently and swivel up to 180° in either direction.
1.
Remove the rear cover and base cover (see
page 31).
2.
Attach the conduit, insulation disk, and swivel disk and configure the set screws to allow for
the degree of swivel that is required (see the SMA-1 Swivel Mount Adapter Kit User Guide,
at www.extron.com).
3.
Place the mounting hole in the base over the conduit of the SMA-1.
4.
Secure the unit with the backing plate and locking nut as described in the SMA-1 Swivel
Mount Adapter Kit User Guide.
VESA Mounting
The TLP Pro 1225TG, 1525TG, and 1725TG touchpanels have VESA FDMI Type D 100 mm
mounting patterns that can be used for VESA mounting with an appropriate third-party mounting
kit.
Before VESA mounting, the base of the touchpanel must be removed.
1.
Remove the rear cover and base cover (see
2.
If necessary, remove cables from the raceway in the base by reversing the procedure
described in
that bundle the cables together.
3.
Remove the screws holding the hinges to the touchpanel.
NOTE:
#6 spanner head screwdriver (not provided).
4.
Lift the TLP away from the base.
5.
Follow the instructions provided with the VESA mounting kit.
1 1 1
TLP Pro 1225TG Base, Showing Kensington Security Slot
Routing Cables (TG Models)
The spanner drive screws holding the hinges require a #6 spanner bit or
TLP Pro 1225, 1525, and 1725 Series • Mounting
Removing the Rear and Base Covers
Removing the Rear and Base
on page 13. If necessary, cut the plastic ties
on
Covers).
32
Advertisement
Table of Contents
