Table of Contents
Advertisement
Status Screen
Status
Info
Model:
Part Number:
Firmware
Version:
Bootloader
Version:
PoE Status:
Figure 8.
Status screen is read-only. The Info panel provides basic information about the
The
touchpanel. Each of the other five panels shows a summary of the information on the other
screens. No values can be changed from this screen.
Pressing any of those five panels opens the corresponding screen in exactly the same way as
pressing the buttons in the top navigation bar.
The green bubble shown in the
red square shown in the
Network Screen
Network screen allows you to set the DHCP status and, if DHCP is set to Off , the network
The
addresses for the touchpanel. Verify with your network administrator whether the IP address for
the touchpanel is assigned by DHCP or set manually. If it is set manually, you need to obtain an
IP address, a subnet mask, a gateway address, and a Domain Name Server (DNS) IP address
from the network administrator.
Status
Host Name:
IP Address:
Subnet Mask:
Gateway:
Figure 9.
1.
If IP addresses are assigned by DHCP, press
manually, press
When DHCP is off, the Host Name is grayed out and cannot be edited. All
•
addresses can be edited (as shown in figure 9).
When DHCP is on, the Host Name can be edited. The addresses are grayed out
•
and cannot be edited because they are set by the DHCP server.
Display
Audio
Network
Network
IP Address:
192.168.254.251
TLP Pro 1225MG
DHCP:
Off
Host Name:
TLP-AB-CD-EF
60-1787-02
1.02.0001-b001
Audio
1.03.0000
Master Volume:
100
Master Mute:
Off
Active
Advanced
Controller IP:
192.168.254.250
Project Size:
1/196 MB
Status Screen
Network panel indicates that there is a network connection. The
Advanced panel indicates that no control processor is connected.
Network
Display
Audio
DHCP
On
TLP-AB-CD-EF
DNS Primary:
192.168.254.251
Domain Name:
255.255.255.0
Mac Address:
0.0.0.0
Network Screen
Off .
TLP Pro 1225, 1525, and 1725 Series • Setup Menu
Input
Advanced
Exit
Display
Resolution:
1280x800
GUI Project:
1280x800
Sleep Timer:
5 Minutes
Input
HDMI Port:
No Signal
XTP:
1280x720
HDCP
Input
Advanced
Exit
Off
127.0.0.1
00-05-A6-AB-CD-EF
Revert
Apply
On . If the IP address is to be assigned
15
Advertisement
Table of Contents
