Table of Contents
Advertisement
Routing Cables (TG Models)
Organize cables behind the rear and base covers for a more aesthetically appealing appearance.
The TLP Pro 1525TG is shown below but the TLP Pro 1225TG and 1725TG are very similar.
1.
2.
3.
4.
5.
6.
Figure 7.
TLP Pro 1525TG Cable Organization
If necessary, remove the rear and base covers and connect the cables as required (see
Removing the Rear and Base Covers
Move the clamp at the back (
where the base and back meet (
If necessary, move the clamp on the base (
Run the cables through the raceways on either side of the center hole (
through the slot at the back of the base (
them organized.
Move the rear and base cable clamps back into position and press them down to secure
them in place.
Put back the rear and base covers. The base cover must be inserted before the rear cover.
TLP Pro 1225, 1525, and 1725 Series • Panel Features
on page 31).
1
) to one side and run the cables through the restricted gap
).
2
) to one side.
5
). Multiple cables can be loosely bundled to keep
5
1 1 1
2 2 2
3 3 3
4 4 4
5 5 5
3
and
4
), and
13
Advertisement
Table of Contents
