Table of Contents
Advertisement
Connecting Power
The TLP Pro 1725MG and 1725TG ship with the Extron PI 140 power injector provided. For
the TLP Pro 1225MG, 1225TG, 1525MG or 1525TG, a power injector must be purchased
separately.
•
•
ATTENTION:
12 VDC Power Supply
Connect a 12 VDC, 3 A power supply to the DC connector on the back of the TLP Pro 1225TG,
1525TG, and 1725TG models.
Power over Ethernet
Figure 6 shows the Extron PI 140. Your power injector may look different.
1.
2.
3.
Alternatively, use an Ethernet cable to connect the XTP/LAN/PoE+ port of the interface to a PoE+
switch or connect the touchpanel directly to an XTP model that is capable of remotely powering
a touchpanel (see the
The TLP Pro 1225MG, 1525MG, and 1725MG must be powered by a PoE power source.
The TLP Pro 1225TG, 1525TG, and 1725TG can be powered by a PoE power source or by
a 12 VDC power supply.
•
Do not power on the touchpanels until you have read the Attention notice on
•
Ne branchez pas les écrans tactiles avant d'avoir lu la mise en garde
Connect a straight-through Ethernet cable
from the power injector to a switch or router
(
1
). This cable carries network information
from the switch or router to the power supply
input.
Connect a second straight-through cable
from the power injector to the XTP/PoE/LAN
connector of the touchpanel (
carries the network information and 48 VDC
from the power injector to the touchpanel.
Connect the IEC power cord to a convenient 100 VAC to 240 VAC, 50-60 Hz power source
(
3
).
note
on page 10).
TLP Pro 1225, 1525, and 1725 Series • Panel Features
100-240V~50/60 Hz
1.1A MAX
3
Extron PI 140
1
To Network or
2
). This cable
XTP Device
Figure 6.
page
12.
page
12.
INPUT
OUTPUT
LAN
POWERED TLP
2
To a TLP Pro
touchpanel
Connecting the Power Injector
11
Advertisement
Table of Contents
