Table of Contents
Advertisement
eBUS Button Panel Decorator-Style Series • Setup Guide (Continued)
Step 8: Mount the EBPs
EBP panels can be installed directly into the wall using a 1-gang or 2-gang (EBP 111D) wall mounting bracket (mud ring) or a
UL Listed junction box. Figures 13 (below) and 14 (on the next page) show how to mount a 1-gang EBP. Use the same procedure
to mount the two-gang EBP 111 D.
ATTENTION:
All electrical installation should be performed by qualified personnel in accordance with local and national building
•
codes, fire and safety codes, and local and national electrical codes.
Toute installation électrique devrait être effectuée par un personnel qualifié, conformément aux codes du bâtiment, aux
•
codes incendie et sécurité, et aux codes électriques locaux et nationaux.
Before mounting:
Decide where to locate the panel. Take into consideration the position of wall studs and windows that could obstruct cable
1.
runs.
NOTES:
For 1-gang products the hole is 3.61 inches (92 mm) H x 2.13 inches (54 mm) W.
•
For the EBP 111 D (2-gang) the hole is 3.61 inches (92 mm) H x 3.97 inches (100 mm) W.
•
EBP products ship with a wall mounting bracket (mud ring). Electrical junction boxes must be purchased
•
separately. Ensure the junction box is the correct size for the EBP.
The EBP VC1 D is deeper than other decorator-style panels and has a front panel rotary encoder that protrudes
•
from the wall more than the buttons of the other models.
Allow at least 1.44 inches (37 mm) depth in the wall or furniture for cables.
•
The EBP VC1 D front panel, including the rotary encoder, extends 0.77 inches (20 mm) from the wall.
•
If required, install an electrical junction box by following the instructions provided by the manufacturer.
2.
To install a wall mounting bracket, see steps 1-3 of "Mounting with a wall mounting bracket," below.
Disconnect power from all devices at the source and run the cables through the wall or furniture.
3.
Connect the cables to the EBP rear panel (see
4.
If you have not already done so, set the DIP switches to give the panel a unique eBUS ID (see
5.
page 6).
Mounting with a wall mounting bracket (mud ring)
Mark the position of the hole on the wall in
1.
the desired location. Use a level to ensure
hole is marked at the correct angle.
Use a drywall saw to cut a hole (
2.
Insert the mounting bracket into the hole.
3.
Use a screwdriver to turn and tighten the
locking arms until they clamp the mud
ring to the mounting surface (
overtighten.
Use the two provided Phillips head screws to
4.
secure the module to the mounting bracket
(
3
).
Use the two screws provided to secure the
5.
frame to the module (
12
EBP Rear and Side Panel Features
1
).
2
). Do not
4
).
Figure 13.
on page 1).
Wall
1 1
2 2
Wall Mounting
Bracket
EBP 106 D
Mounting with a Wall Mounting Bracket
Step 4: Set the eBUS ID
on
3 3
4 4
Frame
Advertisement
Table of Contents
