Display Screen - Extron electronics TouchLink Pro Series User Manual

Display Screen

Status
2
3
4
Minutes
Figure 13.
Display screen allows you to set the Sleep Timer , Auto Brightness ,
The
LCD Brightness , and Wake on Motion .
• Sleep Timer — Toggle between
If the sleep timer is on, after a period of inactivity, the screen goes dark to save power
•
(Sleep mode). Use the up and down arrows to set how long the period of inactivity
should be. The value can be between 1 and 120 minutes.
If the sleep timer is Off, the panel does not enter sleep mode.
•
•
Auto Brightness — Toggle between
Auto Brightness is on, the light sensor (MG models: see
If
•
page 6; TG models see
ambient light detected and automatically provides a suitable amount of screen
backlighting for the situation.
Auto Brightness is off, the screen brightness is not affected by changes in the
If
•
ambient light.
• LCD Brightness — Use the slider control to adjust the screen brightness between
100 .
• Wake on Motion — Toggle between
in sleep mode.
Wake on Motion is on, and the touchpanel is in sleep mode, any motion detected
If
•
by the motion sensor (MG models: see
figure
buttons become functional.
Wake on Motion is off, the panel does not wake in response to nearby motion, and
If
•
the touchpanel can be activated by pressing anywhere on the screen.
Configuring the Motion Sensor
Motion Sensor (see
The
touchpanel, and at least 15° from the center axis.
Sleep Timer has been set and no motion has been detected for a user-defined
•
If the
period of time, the touchpanel enters sleep mode.
Sleep Timer has not been set, the touchpanel does not enter sleep mode.
• If the
Wake on Motion has been set and motion is detected by the sensor while the screen is in
•
If
sleep mode, the screen display is restored and active.
Wake on Motion has not been set and the screen is in sleep mode, touch the screen to
•
If
restore it to an active state.
Network Display Audio
Sleep Timer
0
On Off
Display Screen
On and Off .
figure
E
3, on page 7) wakes the panel from sleep mode. The screen lights and all
E
figure 2,
TLP Pro 1225, 1525, and 1725 Series • Setup Menu
Input Advanced Exit
Auto Brightness
On Off
LCD Brightness
50 100
Wake on Motion
On Off
On and Off .
A
3, on page 7) monitors the amount of
On and Off . For this to work, the touchpanel must be
figure 2, E
, on page 6; TG models see
) detects motion between three to five feet from the
A
figure 2, , on
0 and
17