Setting⑱ : Overlap Output - Mitsubishi Electric KD Series User Manual

5-2 Setting⑱: Overwrap Output
Address Register name
7120h OverlapEnable
5-2-20 Overwrap output
This function enables to add first 144 pixels data@600dpi (6.1mm width of
image ) of a next module on the output of a module.
KD-DXL CIS
Signal Processing
Board
Pixel data between
modules(Signal block)
Pixel data between
channels
Ch1 Ch2
Ch1:6,048pix+144pix,
Ch2:6,048pix+144pix(L4)
×RGB
Ch1:6,912pix+144pix,
Ch2:6,912pix+144pix(L5/L6)
×RGB
TM-XJ959A
R/W Parameter
Data
Set Overwrap output(between the multi signal blocks , and
between the multi channels) On/Off
R/W 0 or 1
0:OFF /1:ON
Sensor Array
Ch1 Ch2
Ch1
Ch1:6,408pix+144pix,
Ch1:6,408pix+144pix,
Ch2:6,552pix (L4)
Ch2:6,552pix
×RGB
(L6)
Ch1:7,704pix+144pix,
×RGB
Ch2:7,848pix(L5)
×RGB
Ch1:6,480pix+144pix,
Ch2:6,480pix+144pix(L6)
×RGB
Function
[Function]
This product have 2 or 3 signal blocks of
Camera Link ® and output image data at
parallel. This product can output image data
from 2 or 3 different signal blocks, which
the image data are overwrapped partially.
This function contribute to acquire the
image data between the multi channels of
Camera Link ® .
By this function, image data near the
connection point can be confirmed correctly
even if using multiple PCs to acquire image.
The number of the added or overwrapped
Ch2
pixels depend of the output resolution. (The
total overwrapped image data correspond
to the 6.1mm width of the acquired image.)
Number of the added pixels :
Camera Link® is a trade mark registered by AIA（Automated Imaging Association).
Initial
0
144 pixels @600dpi
72 pixels @300dpi
48 pixels @200dpi
36 pixels @150dpi
85
© Mitsubishi Electric Corporation