Setting⑮ : Overlap Output - Mitsubishi Electric KD Series User Manual

Address Register name
7120 OverlapEnable
5-2-16 Overwrap output
This function enables to add first 144 pixels data (6.1mm
width of image ) of a next module on the output of a
module.
KD-CX CIS
Signal processing board
8,640 pixels
+ 144 pixels
× RGB
TM-XH719C
5-2 Setting⑮: Overwrap output
R/W Val
R/W 0 or 1
Sensor array
Pixel data
5,184 pixels (L2)
10,368 pixels (L3)
× RGB
COPYRIGHT©2017-2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
Set Overwrap output On/Off
0:OFF /1:ON
[Function]
L2 type and L3 type have 2 channels of CoaXpress® and
output parallel image data. This product can output image
data from 2 different channels, which the image data are
overwrapped partially. This function contribute to acquire
the image data between the 2 different channels of
CoaXpress® .
The number of the added or overwrapped pixels depend of
the output resolution. (The total overwrapped image data
correspond to the 6.1mm width of the acquired image.)
Number of the added pixels :
144 pixels @600dpi
72 pixels @300dpi
48 pixels @200dpi
36 pixels @150dpi
CoaXPress® is a trade mark registered by JIIA (Japan Industrial Imaging Association).
Result Initial
0
87