Status Led - Mitsubishi Electric KD Series User Manual

4-2 Status LED

4-2-1 Status LED
L4(KD6R1064DXL-NL)
L5(KD6R1247DXL-NL)
L6(KD6R1688DXL-NL)
LED status
LED off
Green
LED on
Green 0.5 sec.
LED blink
Red 0.5 sec.
LED blink
TM-XJ959A
Ch1
Ch2
Ch3
Ch4
CIS Status
No Power
Link established,
no stream transfer
Link established,
transferring stream
CRC error
Camera Link® is a registered trademark of AIA (Automated Imaging Association).
【Status LED】
Status LED is located on the back of CIS.
Status LED shows the status of communication status and
CIS.
【 Status of CIS 】
Combination of the 4 status LED shows the status of CIS.
ＬＥＤ状態
Ch1〜3: Red LED on
Ch4: OFF
Ch1,4: OFF
Ch2,3: Orange LED on
Ch1:Orange LED on
Ch2〜4: OFF
Ch1,2,4: OFF
Ch3:Orange LED on
Ch1〜3: OFF
Ch4:Orange LED on
ステータス
FPGA abnormal
temperature of I/F board
System boot
(FPGA configuration
of I/F board)
System boot
(FPGA reset status
of I/F board)
System boot
(Initialize IF board and
CIS booting)
Power supply voltage is not
enough
(Less than 3.4V)
61 61
© Mitsubishi Electric Corporation