Appendix B: Error Indicator - Mitsubishi Electric KD Series User Manual

Appendix B: Error indicator

LED indicator on this product shows this product's status (refer to Chapter 4-2) and
Error indications based on register values (refer to Chapter 5-2-23).
The details of this error indicator and counterplan are described in below.
Item Status
Status LED indicates Orange after turn on CIS
1
Status LED indicates Orange after turn on CIS.
（①Ch1,4: OFF Ch2,3 Orange
②Ch1: Orange Ch2〜4: OFF
③Ch1〜2,4: OFF Ch3: Orange）
2
① ②
Ch1-Ch3 of status LED indicate Solid RED
（Ch1〜3: Red LED ON）
3
TM-XJ959A
This status shows that DC5V power supply voltage down to 3.4V on CIS
internal board.
Change power supply voltage to maximum voltage within Standard
Ch1
Ch2
Operating Conditions and Check the voltage is 5V near the power supply
Ch3
Ch4
connector on CIS.
If voltage is 5V, CIS might be broken or damaged.
This status shows a failure of System-boot operation of this product. If an
appropriate voltage is not provided to CIS, this status happens. Please
check the following points.
①Is the same voltage supplied as the pin assignment table supplied to each
terminal of the V1V3 connector that supplies DC5V? (If +5V and GND pins
specified on the pin assignment table are not connected, the sensor
board cannot operate correctly.)
②Is the current limiter setting of your DC5V power unit too low when
power on?
③
③Is the voltage of DC5V less than 4.75V?
If not above, CIS might be broken or damaged.
This status shows an abnormal temperature of FPGA on I/F board. Make
sure if the surrounding temperature of this product is high or not.
When necessary, please carry out additional cooling solution to this
product.
Contents of errors and counterplan
© Mitsubishi Electric Corporation
97