Startup Procedure - Mitsubishi Electric KD Series User Manual

4-1 Startup procedure

Power on CIS
Confirm boot up of CIS
UART communication settings
via Camera Link®
Control CIS by
frame grabber control software
(Refer to Chapter 5 for details on
control functions)
(Refer to Appendix A
for the register list)
TM-XJ959A
• Supply 5V power
• Status LED will turn to green after boot up.
Boot up period after power on is about 30seconds.
• Settings of this product can be controlled by UART via
SERTC/SERTFG
• Baud rate (initial setting) is 9.6kbps.
• The picture data can be taken by software which is
attached with grabber board.
Camera Link® is a registered trademark of AIA (Automated Imaging Association).
pin on the Camera Link®.
© Mitsubishi Electric Corporation
60