Breakdown Maintenance - Seeley Climate Wizard CW-P15 Installation Operation & Maintenance

MAINTENANCE INSTRUCTIONS
• Lock the handle extension into the front core clamp handle.
• Push down the rear seal clamp handle to engage the clamping
of the rear core seals, lock into position with the swinging cam.
• Replace hose snap fit connectors to the spreaders.
• Push down on the rails that seal the top front core seals and
Recheck all clamps and connectors are engaged properly.
• Cycle the watering of the cores to check for leaks from the
hose snap fit connectors.
• Replace top hatch cover and utility cover.
• Replace filter trim components, filters and louvre panel.

BREAKDOWN MAINTENANCE

Replace or service supply or exhaust fans
Purpose:
To replace a non-functioning supply fan motor, note the exhaust
fan procedure is similar but with fewer steps.
Method:
• Turn off Power to the cooler.
• Remove the section of ductwork attached to the cooler to gain
access to the fan area.
• Remove the fans by loosening the grub screw that secures it to
the motor shaft. Use an 3mm hex key. When replacing the supply
fan motor, remove both the supply and exhaust fans for better
access to the inside of the cooler.
| CW-P15 Indirect Evaporative Cooler 859740-G
25
ILL3551-A
ILL3551-A
ILL3552-A
ILL3552-A
ILL3553-A
ILL3553-A
ILL3554-A
ILL3554-A
• Open the electronics cover and electronics enclosure.
• Unplug the motor power boot-lace wire terminations from the
terminal blocks
• Pull the cable through the cable gland in the electronics
enclosure and through the two cable glands in the plastic
housings.
• Unplug the communications cable connector from the control
PCB.
• Unscrew the four bolts in the corners of the plate venturi
shroud. 12mm on ½" socket or spanner.
• Carefully pull the fan assembly out supporting its weight. It
will still be attached to the cooler by a pivoting arm. This arm
will take the weight of the fan assembly and will allow the
assembly to tilt outside the cooler.
ILL3555-A
ILL3555-A
ILL3556-A
ILL3556-A
ILL3557-A
ILL3557-A
ILL3558-A
ILL3558-A