Table of Contents
Advertisement
MAGIQCOOL CONTROL OPERATION
Auto Mode
This 'setpoint' temperature can be adjusted by pressing
the "
" or "
" buttons whilst the 'setpoint'
temperature is being displayed. After a few seconds the
wall control will stop displaying the 'setpoint' temperature
and will return to the 'room' temperature.
Delayed Start and Stop
The cooler can be programmed to start at a specific time
or stop at a specific time.
The delayed start time can only be programmed when
the cooler is OFF. To program the cooler to start in a
certain amount of hours use the following sequence:
Programming in Manual Mode
Press the "
" button.
1.
Press the "
" button until "MAN" is displayed on
2.
the screen.
Press the "
" or "
3.
fan speed is displayed by the bars in the middle of the
screen.
Press the "
" button to set either COOL or VENT.
4.
5. Press the "
" button and
the 'starts in' time will start
flashing. Use the "
"
" buttons to select the
desired time.
6. Press "
" again.
Programming in Auto Mode
1. Press the "
" button.
2. Press the "
" button until flashing "AUTO" and set
temperature are displayed on the screen.
3. Press the "
" button and the 'starts in' time will start
flashing. Use the "
hour.
4. Press "
" again.
The delayed stop time can only
be programmed when the cooler is
ON. To program the delayed time
in which you want the cooler to
stop use the following sequence:
Select the "
" button and the 'stops in' time will
1.
start flashing. Use the "
to select the desired off time.
Press "
" again.
2.
NOTE: Delayed start and stop times must be re-set every
day that they are required.
|
CW-P15 Indirect Evaporative Cooler 859740-G
17
" button until the desired
Man
" and
Cool
Starts in
hrs
ILL1711-A
" or "
" button to select the
Auto
Stops in
hrs
" and "
" buttons
Testing the Cooler
Once you are satisfied that the cooler is installed
correctly, run the cooler to ensure that everything is
working as it should. We recommend that you have a
short test lead on hand for coolers with a hard wired
control system. You can then take the wall control to the
roof and control the cooler from there.
The short test leads are available from Seeley Spare
Parts Distributors
(P/No: 1.5m - 862873).
(P/No: 3.0m - 861265)
Turning Cooler On, check fan operation
Press the "
" button to start the cooler. Press the
"
" button to switch to "Vent"mode which will disable
the pumps.
Press the "
" and
"
" to vary the fan
speed and check fan
operation.
Checking Pump Operation
Press the "
" button to switch to "Cool" mode. With
control in "Cool" mode, check the pump function and
the start-up sequence. The solenoid will open and water
begin to fill the tank. Once water reaches the top probe,
the pump will start.
Checking Drain Operation
Ensure there are no water leaks. Drain the reservoir by
pressing both the "
with the wall control in the "OFF" state. Check the drain
fittings and pipes, making sure there are no leaks.
ILL1712-A
ILL1118-A
" and "
" buttons together,
ILL1704-A
ILL1704-A
ILL1705-A
ILL1705-A
ILL1706-A
ILL1706-A
Hide quick links:
Advertisement
Table of Contents
