Seeley Climate Wizard CW-P15 Installation Operation & Maintenance page 35

USER MAINTENANCE INSTRUCTIONS
TRI-COLOURED LED - cont.
This LED indicates the status of the cooler and indicates Fault
Codes (if applicable).
Cooler Fault
LED
Status Description
8 Red Warm Start If the mains input
Flashes voltage is under
then 2 90Vac but not low
seconds enough to reset the
OFF PCB, the system
switches off the
Fan and Pump
and indicates this
Fault. If the Voltage
returns to a usable
voltage level without
resetting the PCB
a Fault Code #8
is recorded in the
system log.
10 Red Chlorinator The Chlorinator is
Flashes Fault Short Circuit,
then 2 Open Circuit,
seconds Degraded or has
OFF Reached end of life.
This fault will
activate a 24 hour
clean tank drain
cycle until remedial
action is taken.
13 Red Motor Error If an Error has
Flashes Exhaust Fan occurred in the
then 2 motor drive circuit.
seconds
OFF
14 Red Watering Cycle A watering cycle
Flashes comprises the
then 2 circulation pump
seconds time, core drain
OFF time, tank fill time
and salinity check.
If the watering cycle
exceeds its preset
time, +1 is added
to a register. If the
next watering cycle
is completed on
time -1 is deducted
from register. If the
register >=3 then the
cooler will continue
to operate with a
warning symbol
displayed on the wall
control.
Check the water
supply to the cooler
is sufficient.
TRI-COLOURED LED - cont.
This LED indicates the status of the cooler and indicates Fault
Codes (if applicable).
MagIQcool MagIQtouch
Fault Code Fault Code
Fault Code #8 08
Fault Code 10
#'A'
Fault Code 13
#D
Fault Code 14
#'E'
Cooler Fault
LED
Status Description
15 Red Pressure If a Pressure sensor
Flashes Sensor Fault becomes blocked or
then 2 is partially blocked
seconds the operation of
OFF the CW could be
severally affected.
Fault Code #15 will
indicate that the
Pressure sensor
are not responding
within anticipated
boundaries for set
supply Fan speeds.
The 2 Pressure
sensors have
different failure
criteria.
SEELEY INTERNATIONAL - INSTALLATION MANUAL CW-P15 859740-G |
MagIQcool MagIQtouch
Fault Code Fault Code
Fault Code 15
#'F'
32