Table of Contents
Advertisement
WALL CONTROL INSTALLATION
MAGIQTOUCH CONTROLLER
Refer to Installation Manual MagIQtouch Controller, Item 1D
included in Installation Components.
CONTROL SYSTEM
Climate Wizard coolers are supplied from the factory with
a MagIQcool Wall Control, a MS1 BMS Control and a 20m
(65') control cable. This makes it possible for the cooler to be
controlled independently and automatically from the zone to
which it is delivering cool air.
The MagIQcool Wall Control incorporates a thermostat
that regulates fan speed to try and maintain indoor
temperature within ±1°C (± 3°F) of the set temperature.
LOCATING THE WALL CONTROL
The wall control should be placed approximately 1.5 m
(5') above the floor, in the general area of the cooled
zone.
Placement of the Wall Control is critical for correct
functioning of the in-built thermostat (incorporated in the
wall control). The following points must be taken into
consideration:
Avoid direct sunlight exposure.
•
Avoid mounting on external walls.
•
Avoid mounting the wall control near heat sources such
•
as room heaters, stoves and TV's.
Do not locate in the direct airflow from the duct outlets.
•
Do not locate in strong drafts or in dead spots such as
•
corners and confined spaces.
Always seal the cable entry hole in the wall. Hot
•
air coming through the wall may interfere with the
temperature measurement.
CAUTION! Always make sure there are no
electrical cables, gas or water pipes, or the
like, behind where you intend to drill.
ILL3530-A
RUNNING THE CONTROL CABLE TO THE WALL
CONTROL
Using the loop on the end, draw the cable through the
wall cavity to the hole made at the wall bracket. Carefully
remove the tape from the cable loops and check that the
plug has not been damaged. Connect the cable to the
wall control and mount the wall control onto its bracket.
Important! Take care not to damage the cable or plug
during this process. Always seal the cable entry hole.
|
CW-P15 Indirect Evaporative Cooler 859740-G
15
MOUNTING THE WALL CONTROL
Fixing the wall control bracket to a plasterboard wall
Use the bracket as a
template.
Drill the 16mm
1.
(5/8") hole for the
wall control cable
Drill the 5mm
2.
(3/16") holes for
the wall plugs.
Insert the wall
3.
plugs into the
holes. Align and
screw the bracket
into position using
the supplied
screws.
ILL1582-A
Fixing the wall control bracket to a brick wall
To mount the wall
1.
control bracket
on a brick wall,
follow the previous
instructions using
the wall plugs and
screws provided.
Note that the wall
2.
plugs require
6mm (1/4")
holes. Mount
the wall control
following the next
procedure.
Fitting the wall control to the mounting bracket
Pull the wall
1.
control cable
through the larger
hole and plug
it into the wall
control.
Feed the excess
2.
cable back into
the hole and seal.
Slide the wall
control over the
protruding bracket
tabs.
Pull the wall
3.
control down so
the bracket tabs
engage and locate
with the keyway
slots on the rear.
2x 5mm / (3/16")
Plasterboard
or 2 x 6mm / (1/4")
16mm Hole
Vertical Alignment
ILL1210-D
BRICK WALL MOUNTING SHOWN
PLASTERBOARD WALL MOUNTING SHOWN
Brick
(5/8")
ILL1210-D
ILL1210-D
ILL1090-B
ILL1090-B
ILL1091-B
Hide quick links:
Advertisement
Table of Contents
