Commissioning; Climate Wizard Cooling Applications; Top View; Testing The Circulation Pump - Seeley Climate Wizard CW-P15 Installation Operation & Maintenance

COMMISSIONING

CLIMATE WIZARD COOLING APPLICATIONS

Climate Wizard is designed to be used in 3 different types of
applications:
• STAND ALONE COOLING - in cases where the Climate
Wizard is the primary source of Air Conditioning for the
building.
• SUPPLEMENTARY COOLING - in cases where the Climate
Wizard is used to augment the capacity of the existing air
conditioning system, or to extend its reach into the building,
or to greatly reduce the energy consumption of the Air
Conditioning plant.
• COLD FRONT COOLING - in cases where the Climate
Wizard is used to pre-cool the fresh air supply to new or
existing refrigerated air conditioning plants in order to prolong
the life of the plants, to save significant energy, and to greatly
reduce demand on existing infrastructure which becomes
over-stressed in heat-wave conditions.
In each application type, remarkable energy savings can
be achieved compared with conventional Refrigerated Air
Conditioning.

TOP VIEW

SUPPLY AIR
(Cool and Dry)
AIR INLET
(Ambient air)
| CW-P15 Indirect Evaporative Cooler 859740-G
19

TESTING THE CIRCULATION PUMP

(This action requires a MagIQcool Controller). Refer to Pg17.
Test the pump by turning the cooler on at the MagIQcool
controller, in "COOL" mode.
Note! If the cooler has not been operating recently it will run
a "Pre-wet" routine where the pump will operate to saturate
the cores. This cycle takes 70 seconds, then the fans will start
automatically.

TESTING THE DRAIN PUMP

(This action requires a MagIQcool controller). Refer to Pg17.

CLEAN UP THE SITE

Clean up and tidy the premises, removing all rubbish.

SHOW THE CUSTOMER THEIR NEW COOLER

Please take a few moments to explain to the customer the
following, along with the principles of Indirect Evaporative
Cooling:
• How much to open doors and windows.
• How to start the cooler.
EXHAUST AIR
• Explain the "Preparing to start" mode.
(Warm & Moist)
• How to operate the cooler "manually".
• How to operate the cooler in "vent" mode only.
• How to operate the cooler in "auto" or "temperature" mode.
ILL3519-A
• How to drain the cooler.
• How to turn the power and water off.
• Maintenance requirements.
ILL3520-A
ILL2277-A
ILL3521-A
ILL1669-A
ILL1670-A