Table of Contents
Advertisement
CLUTCH MAGNET AND LATCH SPRING
Requirement
The clutch disc should be in the center of
the latch spring, and the shoe release arm
should be central to the end of the stop
lever as gauged by eye.
To Adjust
Remove line feed magnet assembly. Loosen
mounting screws friction tight. Position stop
lever and latch spring. Tighten mounting
screws.
ISS 3, SECTION 582-210-700
LATCH SPRING
.-p
STOP
(Bottom View)
LEVER
Note:
Perform CLUTCH STOP LEVER adjustment after reassembling line feed.magnet assembly.
CLUTCH SHOE RELEASE ARM
Requirement
There should
be
Min
0.065" --- Max 0.095"
gap between the shoe release arm and the stop lug while the clutch is engaged.
To Measure
Momentarily disengage clutch by pulling against shoe release arm. After reengaging the clutch momen-
tarily apply 16 ounces of tension on shoe release arm in a direction to give a maximum gap. Rotate
clutch disc in a direction to close the gap with sufficient force to overcome the disc spring tension until
clutch disc is at rest against its positive stop. While holding clutch disc against its stop, measure gap be-
tween shoe release arm and stop lug of the clutch disc.
To Adjust
Loosen two plate clamp screws friction tight.
Rotate clutch disc until the requirement is
met. Tighten clamp plate screws.
Note:
This adjustment is to be made before
the clutch assembly is assembled
to
the line
feed mechanism mounting plate and before
the plastic output pulley is installed.
To Check the Requirement When the Clutch
Assembly is Installed in a Unit:
Hold the clutch drum pulley to prevent it from
moving. Trip the clutch magnet. While holding
the clutch drum pulley from rotating momen-
tarily apply 16 ounces
to
shoe release arm in a
direction to give a maximum gap. Rotate clutch
drum pulley in a direction to close the gap with
sufficient force to take up all the play. While
holding clutch drum pulley in this position
measure the gap.
CLUTCH DISC
Page 9
Advertisement
Table of Contents
