Paper Guide Positioning - Bell DATASPEED 40 Adjustments And Lubrication

SECTION 582-210-700
PAPER GUIDE POSITIONING (40P101 Friction Feed Printer)
(Early and Interim Design)
Note:
This adjustment does not apply to late design 40P101 printer equipped with a 400377 front
casting assembly.
Requirement (Interim Design)
The paper guide should be flush against the upper part of the casting at both right and left sides.
To Adjust
Remove type carrier and ribbon. Loosen the two mounting screws, position guide against the
casting, and tighten screws.
Note: (Interim Design and Early Design) This is a manufacturing adjustment and should not be disturbed
unless the printer paper guide has been disassembled.
PAPER GUIDE
FLUSRHERE
(Interim Design)
Requirement (Early Design)
There should be
Min some --- Max 0.010 inch
clearance between paper guide and paper guide adjusting screw.
To Adjust
Remove type carrier and ribbon. Position paper guide adjusting screws to meet requirement.
(Early Design)
(Left Side View)
Page 18