Bell DATASPEED 40 Adjustments And Lubrication page 51

ISS 3, SECTION 582-210-700
.fQBM-OUT CQNTACT TO BELT SPACING (Final) - Tractor Feed and Forms Access Printers (Cont)
Requirement
(C)
(Form-Out Contact Phasing)
"V" part of contacts should be positioned in center of long cam as gauged by eye.
eLatch the line feed clutch.
ePosition form selector lever in the fourth detent position.
eMove feed pawls out of engagement with the line feed gear.
-Rotate paper advance knob until the slope part of the contact just touches the long cam.
~Just
Touches
- Reengage the line feed pawls .
• Reengage paper advance knob.
To Check
(1) Manually energize line feed magnet.
(2) Rotate line feed clutch.
(3) Latch line feed clutch.
To Adjust, Recheck Form-Out Contact to Belt Spacing (Final) Requirements (A) and (B).
Page 51