Table of Contents
Advertisement
SECTION 582-210-700
PAPER POSITIONER (Under Power)
(80-Column Friction, Tractor Feed, or 132-Column Tractor Feed)
Requirement (A)
"The paper should be positioned as close to ribbon as possible without causing printed copy to become
illegible due to ribbon smudging after a one minute printer idle period.
Requirement
(B)
There should be no smudge when printing a text message (not the font identification symbol).
Friction Feed Printer
Tractor Feed Printer
(Left
Side View)
PAPER POSITIONING
SHAFT
CLAMP SCREW
PAPER POSITIONER
ARM
PAPER POSITIONER
SHAFT
Note
1: These requirements do not apply when printing within two lines of a fold of fanfold paper.
To Adjust
Loosen clamp screws on left and right paper positioner arms and adjust arms to just eliminate marking
on either side of paper. Paper should remain as close as possible to ribbon without marking to minimize
impact noise and vertical misalignment. Tighten clamp screws.
PAPER POSITIONING
SINGLE COpy
SHAFT
PAPER
/(See Notes 1 and 2)
BACKSTOP
/
c~ cs~~
TYPE PALLET
BACKSTOP
CLAMP
SCREW
RIBBON
MULTICOPY
PAPER
(See Notes 1 and 2)
.-=r----~ B~ER
TYPEPALLET~,~.~
Tractor Feed
Staples or other means of fastening copies together
should not be used until tested to insure that their
presence will not interfere with the ribbon, printer
hammers, or type pallets.
TRANSFER MEDIUM
OR CARBON PAPER
Note
2: Tractor Feed Printers Only - The factory final adjustment is made with a standard original plus
three copies paper on the 132-column printer and with a standard original plus five copies paper on 80-
column printer. Upon installation a refinement of this adjustment may be necessary dictated by the actual
paper weight and number of copies being used.
Page 38
Advertisement
Table of Contents
