Left Ribbon Bracket; Mask - Bell DATASPEED 40 Adjustments And Lubrication

ISS 3, SECTION 582-210-700
MASK
(40P102 Friction Feed Printer Only)
Requirement
There shall be some clearance between the top and bottom edges of the mask slot and the top and
bottom of the No.1 and No. 80 hammers.
To Adjust
Pull pressure release lever forward. Loosen two mask mounting screws friction tight. Position mask to
meet requirement. Tighten screws.
LEFT RIBBON BRACKET
(Friction Feed Only)
Note: This adjustment does not apply to late design units equipped with "black" bracket.
Requirement
The right surface of the bracket shall be flush to the casting.
To Adjust
Loosen bracket mounting screws. Position bracket to meet requirement. Tighten screws.
MOUNTING
SCREWS
Page 13