Bell DATASPEED 40 Adjustments And Lubrication page 16

SECTION 582-210-700
PAPER-OUT SWITCH (Early and Late Design)
(132-Column Tractor Feed Printer)
(Early Design)
Requirement
The paper-out switch should trip when paper-
out switch arm is positioned
Min 0.075 inch --- Max: 0.095 inch
from rear paper guide.
To Check
Place a gauge between end of paper-out switch
arm and rear paper guide. The switch should
trip before arm contacts 0.075-inch gauge and
should not trip when lightly held against a
0.095-inch gauge.
To Adjust
Loosen two switch clamp screws friction tight.
Position switch about its pivot point to meet
requirement. Tighten clamp screws.
(Late Design)
(1) Requirement
The paper-out switch should trip when the
paper-out switch arm is positioned
Min 0.075 inch
from the rear paper guide.
(2) Requirement
With the paper-out switch arm touching the
rear paper guide there should be
some clearance
between the switch case and the switch lever.
To Measure
Place a 0.075 inch gauge between the end of
the paper-out switch arm and the rear paper
guide. The switch should trip before the arm
contacts the gauge. Remove the gauge and
position the lever against the rear paper guides
while checking for some clearance between the
switch case and the switch lever.
To Adjust
Loosen the two switch clamp screws friction
tight. Position the switch about its pivot point
to meet these requirements. Tighten the clamp
screws.
Page 16
(Early Design)
(Late Design)