Table of Contents
Advertisement
SECTION 582-210-700
CLUTCH STOP LEVER
(Early and Late besign)
Requirement
The top surface of the
clutch stop lever shoUld be
Min flush --" Max 0.005 inch
overflush with the top sur-
face of the shoe release arm.
To Adjust (Early Design)
Loosen magnet assembly
post and mounting screw
friction tight. Position
magnet assembly to meet
requirement using the pry
points. Tighten mounting
screw and mounting post.
To Adjust (Late Design)
Loosen magnet assembly
mounting nut and armature
stop lever mounting screw
friction tight. Position arma-
turestop lever so that the
clutch stop lever meets the
requirement. Tighten arma-
ture stop lever mounting
screw and nut securely. Check
the other 5 clutch positions.
LINE FEED ARMATURE GAP
(Early and Late Design)
Requirement
A 0.025 inch gauge shall enter
the armature and magnet core
measured in Iirie with the
outer surface of the l)1agnet
core but will not pass beyond
the inidpoint
of
the pole face.
To Adjust (Early Design)
With locknut lo.osened, make
the adjustment using the ad-
justing screw. Tighten lock-
nut.
Page 10
(Left Side View)
(Early Design)
MAGNET ASSEMllLY
MOUNTING SCREW
\
/
SHOE
RELEASE
ARM
MAGNET ASSEMBLY
MOUNTING POST
CLUTCH
DRUM
MAGNET ASSEMBLY
MOUNTING NUT
ARMATURE STOP
CLUTCH
MAGNET ASSEMBLY
MOUNTING POST
f1't:-~\ /
~2lJ1- (O~
t /...
l.u":
'~' ~~~
/
SHOE
RELEASE
ARM
(Late Design)
(Early Design)
A 0.025 INCH GAUGE WILL NOT
PASS MIDPOINT OF POLE 'PIECE
ARMATURE
ASSEMBLY
Advertisement
Table of Contents
