Bell DATASPEED 40 Adjustments And Lubrication page 55

ISS 3, SECTION f'82-210-700
RIBBON TRACKING (For 80- or 132-Column Tractor Feed Printers equipped with reinker mechanism
and for 40P253 Forms Access Printer) (Cont)
RIGHT
t;l;:BIlt.;ll:;"""!I- ECCENTRIC
SCREW
40P253 Forms Access Printer
MOUNTING
SCREW
Note:
On units equipped with reinker mechanism, if the ribbon cannot be made to track properly, check
and see that the posts on the ribbon feed mechanism are square and that the retainer bracket (408989 on
80-column or 402903 on 132-column) has the correct angle for the guide posts. The correct angle between
the top surface of the bracket and the top surface of the two ears, used to mount the ribbon guide posts,
should be approximately 234 degrees on SO-column printer or 229 degrees on 132-column printer.
SO-Column Printer
132-Column Printer
Page 55