General - Bell DATASPEED 40 Adjustments And Lubrication

SECTION 582-210-700
1. GENERAL
1.01
This section provides adjustment and
lubrication procedures for the DATA-
SPEED 40 printers (Fig. 1, 2, 3, and 4).
Fig. 1-40P101 and 40PI02 80-Column
Friction Feed
Fig. 2-40P151, 40P153, or 40P154
80-Column Tractor Feed
Fig. 3-40P201 or 40P202 132-Column
Tractor Feed
Page 2
Fig. 4--40P253 80-Column Forms
Access Printer
1.02 This section is reissued to add the adjust-
ments for the 40P102 80-column friction
feed printer (noise reduced), 40P154 SO-column
tractor feed printer, and 40P253 80-column forms
access printer.
1.03 Unless specified otherwise, adjustments
and lubrication apply to all printers
(80-column friction and tractor, 132-column
tractor, and forms access).
Note:
When ordering replaceable components,
prefix each part number with the letters "TP"
(ie, TP123456), unless specified otherwise.
1.04 Refer to Maintenance Tools, Section
570-005-S00 for a complete listing of the
various types of hand tools available to make the
adjustments. Gauge 402617 (SO-column forms
access, SO-column friction or tractor), 402716
and 402717 (132-column tractor), and two
40S765 gauges (132-column and forms access) are
required for certain adjustments. Also, 40286S
dynamic backup bar gauge and 402878 type
carrier alignment gauge are used in adjusting SO-
column friction or tractor, 80-column forms
access, and 132-column tractor printers.
1.05 To remove the printer from the cabinet,
reverse the procedure in Section 582-210-
200 covering installation of the printer.
1.06 Use maintenance pad 124828 to protect
bench top or floor coverings from oil,
grease, and dirt while adjusting or lubricating
the unit.