Backup Bar To Carrier Track; Installation Of 408765 Adjusting Gauges For Backup Bar To Carrier Track Adjustment - Bell DATASPEED 40 Adjustments And Lubrication

SECTION 582-210-700
INSTALLATION OF 408765 ADJUSTING GAUGES FOR BACKUP BAR TO CARRIER TRACK
ADJUSTMENT (132-Column or Forms Access Printer)
0Remove ribbon.
0Remove tear bar assembly (forms access printer only).
Remove type carrier.
BACKUP BAR TO CARRIER TRACK
(132-Column or Forms Access Printer)
Note: This is a manufacturing adjustment and should not be disturbed unless carrier track channel has
been replaced or disassembled.
Requirement
The backup bar should just touch engaging surfaces of 408765 gauges two of which are positioned
adjacent to backup bar mounting screws.
To Adjust
With the two backup bar mounting screws friction tight, and the two 408765 gauges in place on carrier
track channel, apply finger pressure to backup bar to lightly contact gauges with engaging surfaces.
Hold in this position and tighten the two backup bar mounting screws.
Note: On 132 column printer, the column indicator must be removed to make the adjustments.
ENGAGING
SURFACES
Forms Access Printer
BACKUP BAR
408765
GAUGES (2\
ENGAGING
SURFACES
132-Column Printer
Note: If the BACKUP BAR TO CARRIER TRACK adjustment is made, the BACKUP BAR (Final
Under Power), LEFT and RIGHT CARRIER SPROCKETS and RIBBON GUIDES adjustments must
also be made.
Page 22