Table of Contents
Advertisement
PAPER-OUT SWITCH (Forms Access Printer)
Requirement
With the left tractor lid closed, under its own
spring load, the "NC" contact will make the
transition to an "open" condition when the
switch-actuator is
Min 0.040 inch --- Max 0.060 inch
from the tractor lid.
Note:
The transition point may be determined
by the "clicking noise" or by checking the con-
tinuity across pins 1 and 4 of connector JI04.
To Adjust
Bend switch lever in an area between the lever
pivot and actuator contact, to meet require-
ment.
ISS 3, SECTION 582-210-700
SWITCH
LEFT TRACTOR LIlJ
ACTUATOR
PAPER JAM ALARM (For 80- or 132-column tractor feed printers
equipped with paper jam alarm mechanism)
ECCENTRIC
POST
Requirement
There should be
Min 0.020 inch---Max 0.040 inch
between the top of the latch and bottom of the
actuator when the cam follower is in the trip
position.
To Adjust
Loosen the eccentric post mounting nut friction
tight. Rotate eccentric to meet requirement.
Tighten mounting nut.
(Position to this
side of mounting
hole prior to
adjustment.)
Latch and cam follower
in tripped position.
Page 17
Advertisement
Table of Contents
