Table of Contents
Advertisement
SECTION 582-210-700
RIBBON GUIDE (Final)
(Friction Feed Printer)
Requirement (1)
There should be
Min 0.010 inch clearance
between ribbon guides and the face of a flag pallet on carriers having three fonts and the face of a font
identification pallet on carriers having two fonts.
To Adjust
Loosen ribbon guide mounting screws friction tight. Position guide to meet requirement. Tighten
mounting screws. Repeat the procedure with the other ribbon guide.
Requirement (2)
There should be
Min 0.006 inch clearance
between the ribbon guides and all pallet faces.
To Adjust
Seat pallets against the rear surface of the front flange of the left sprocket.
Friction Feed
Printer
- I .
See Req
1
I
MOUNTING SCREWS
I
i
I
and Req 2.
II~
~
~~i
(Left Side View)
~
PALLET
LEFT RIBBON GUIDE
(See
(1)
Req
PRY POINT
RIBBON GUIDE (Final)
(80-Column Tractor Feed Printer)
Requirement (1)
There should be
Min 0.010 inch clearance
and
(2)
Req)
PRY
POINT
(Right Side View)
RIGHT RIBBON GUIDE
between the ribbon shield where it contacts the ribbon guides and the face of a flag pallet on carriers
having three fonts and the face of a font identification pallet on carriers having two fonts.
To Adjust
Loosen ribbon guide mounting screws friction tight. Position guide to meet requirement. Tighten
mounting screws. Repeat procedure with other ribbon guide.
Requirement (2)
There should be
Min 0.006 inch clearance
between the ribbon shield where it contacts the ribbon guides and all pallet faces.
To Adjust
Seat pallets against rear surface of front flange of left sprocket.
Page 34
PALLET
(See
(1)
Req
I--
and
(2)
Req)
--ll:
1~jf=
!rO~RIBBON
J/".
~~
SHIELD
~
LEFT RIBBON GUIDE
SPRING
RIGHT RIBBON
GUIDE
MOUNTING SCREW
Advertisement
Table of Contents
