Clutch Bidrec Gap; Clutch Shoe Release Arm Spring - Bell DATASPEED 40 Adjustments And Lubrication

SECTION 582-210-700
CLUTCH BIDREC GAP (Friction Feed Printers) (Early Design)
• Clutch engage.
Requirement
Gap between clutch adjusting disc post and
shoe release lever
Min 0.002 inch --- Max 0.018 inch
from machines operated under 100 hours --
Min 0.002 inch --- Max 0.025 inch
for machines operated over 100 hours.
To Adjust
If
requirement cannot be met, replace clutch
shoes and/or clutch drums.
CLUTCH SHOE RELEASE ARM SPRING
• Engage clutch .
• Hold clutch disc .
• Pull with scale on shoe release arm tangent
to the clutch.
Requirement
Min 16 oz --- Max 22 oz
to move the shoe release arm into contact
with the stop lug.
To Adjust
Remove clutch assembly and replace 150241
spring.
CLUTCH ADJUSTING
PLATE
SHOE RELEASE LEVER
SHOE
RELEASE ARM
o
LUTCH ADJUSTING
DISC POST
(Early Printers Only)
(Rear View)
STOP LUG
(Left Side View)
DRUM
DISC
Page 8