Table of Contents
Advertisement
ISS 3, SECTION 582-210-700
FORM-OUT CONTACT LATERAL (Preliminary) (Tractor Feed Printers)
(Early Design Only)
CONTACT ASSEMBLY
~e
.
.
MOUNTING SCREWS
q
ReqUirement
.
FORM SELECTOR
FORM-OUT
Form-out contact assembly should be
POSl-
LEVER
CONTACT
1
tioned on form selector lever such that the
form-out contact tip is
0
Min 0.215 inch --- Max 0.231 inch
from outside surface of the form selector
lever.
To Adjust
Loosen two contact assembly mounting screws and position contact to meet requirement. Tighten
mounting screws.
Note 1:
This adjustment must be made before form selector lever is assembled to contact housing
bracket.
Note 2:
Factory Adjusted - Should not normally require adjustment unless contact assembly has been
removed.
FORM-OUT CONTACT LATERAL (Final) (Tractor Feed and Forms Access Printers)
(Early Design and Late Design)
Requirement
(A)
The contact should be centered (as gauged by eye) on the short cam lobes.
Requirement (B)
The form-out contact must not touch the adjacent cam lobes when in positions 3 and 4.
Req A
Req B
To Check
(A)
With the form-out belt positioned against the flange of the form-out drive gear and in position No.4.
To Check (B)
Rotate form-out gear.
To Adjust (Early Design)
Disassemble and refine FORM-OUT CONTACT LATERAL
(Preliminary).
To Adjust (Late Design)
Loosen the two contact assembly mounting screws and
position contact to meet requirements. Tighten
mounting screws.
Late Design
(Screw Accessibility)
Page 45
Advertisement
Table of Contents
