Installation Of 402716 And 402717 Gauges - Bell DATASPEED 40 Adjustments And Lubrication

ISS 3, SECTION 582-210-700
INSTALLATION OF 402617 ADJUSTING GAUGE (Cont) (80-Column Friction or Tractor)
0With ac power off, remove paper and ribbon.
With type carrier removed, insert 402617 gauge on type carrier track with front edge against backup
bar. Position gauge so protrusions at rear line up with no. 1 and no. 80 print hammers.
POSTS ARE REMOVED
FOR FRICTION FEED
PRINTER GAUGING
(Spacers on posts
are present on early
design only and are
not required for
any adjustment
procedure.)
TYPE CARRIER
TRACK
Early Design
(Left Front View)
80-Column Friction
Feed Printer
BACKUP
BAR
80-Column Tractor
Feed Printer
(Left Front View)
Late Design
INSTALLATION OF 402716 AND 402717 GAUGES (132-Column Tractor Feed Printer)
0.-
With ac power off, remove paper and ribbon.
@Remove type carrier per instructions on cover.
G)Position 402716 (left) and 402717 (right) gauges on top of track and against backup bar.
(Left Top View)
HAMMERS
GAUGE
LOCATION
(Right Top View)
Page 25